AUTOMATIC FLASH POINT TESTERS
The Setaflash Series 8 'ActiveCool' is an automated closed cup flash point tester with a temperature range of 10 to 130°C (50 to 266°F) with no external cooling required. When connected to a suitable chilled water supply, the range is extended down to -20°C (-4°F).
There are two modes of operation; Flash / No Flash and Ramp. The ramp mode increases the sample temperature at a rate of 2°C/min and automatically dips the ignitor every 1°C up to 100°C (every 2°C above 100°C), until either a flash is detected or the end of test temperature is reached.
Temperature range (Air cooled)
10°C to 130°C (50 to 266°F)
Temperature range (Water cooled)
-20°C to 130°C (-4 to 266°F)
Flash point testing at low temperature
For tests with a starting temperature of 10°C (50°F) or lower, the Series 8 Active Cool must be connected to a chilled water supply that is maintained at 5°C with a flow of at least 0.6l/min.
Stanhope-Seta Mini Low Temperature Bath/Circulator 99300-4 is an approved chiller for this application.
Petroleum - Fuels & Oils |
Crude Oil |
Aviation |
Lubricants |
Greases |
Biodiesel |
Paint, Varnish & Waxes |
Pharmaceuticals |
Printing Inks |
Waste & Environmental |
SPECIFICATIONS | |
---|---|
Temperature Range | Air: 10 to 130°C (50 to 266°F) Water Assisted: -20 to 130°C (-4 to 266°F) using 99300-2 |
Sample Size | 2 or 4ml according to method |
Ignitor | Electrical Hot Wire |
Test duration, Rapid Equilibrium Mode | 1 minute below 100°C, 2 minutes above 100°C, FAME 1 minute or user defined 1 to 99 minutes |
Test duration, Ramp Mode | Typically 7 minutes |
Cool Down Time | 80 to 20°C (176 to 68°F) in 4 minutes |
Sample Cup Material | Corrosion resisting steel insert, aluminium cup |
Heating / Cooling Method | Peltier Cell |
Computer Interface | RS232C (USB & LAN options) |
Voltage | 100 to 250V, 50/60Hz (2x AA dry cell batteries required for internal clock) |
Power | 300W (maximum) |
Size (HxWxD) | 30 x 34 x 38cm |
Weight | 8kg |
CCCN Code: | Tariff 90268020 |